Cooperations

instructions for the construction set

assembly instructions

Unpacking and sorting:

Unpack all the parts and sort them. This will help you keep track of everything and make assembly easier.

Prepare spacers (4x):

Unscrew the spacers. You have to do this four times.
Each spacer has two clear sealing rings. Put these aside - you will need them later.

Prepare the necessary parts:
For the next step you need:

4 screws, 4 spacers, 4 suction cups, the small multi-tool

Assemble spacers:

Place the screws on the screwdriver and align them upwards.
Slide the open spacer over the screw. It may be a bit wobbly at first, but with a little patience it will work!
Hold the spacer and screw and screw the suction cup onto it.
Repeat this step with all four spacers.

Attach spacers to the plate:

Screw the finished spacers to the plate.
Make sure that you place one sealing ring in front of the plate and one behind it. Repeat this for all four spacers.

Installation of the shower head:

Take the transition piece and insert a sealing ring.
Screw the lock nut onto the bracket. Turn the lock nut all the way back until it stops moving.
Push the angle through the plate from behind and screw the transition piece with the sealing ring onto the front by hand.
For additional support, you can use the multi-tool to tighten everything. If leaks do occur later, you can put two sealing rings in the transition piece and screw the lock nut against the plate from behind to secure the angle.

Attach the shower head and hose:

Screw the shower head onto the adapter.
Place a sealing ring into the cone of the shower hose and attach it to the angle.
Place another sealing ring into the hex screw of the shower hose and screw it onto the 3-way adapter.

Attach suction cups:

Stick an adhesive pad on each suction cup and peel off the white film.
Press the suction cups firmly onto the tiles. Make sure that no air bubbles form and that you do not stick the shower to a joint. Press everything firmly for about a minute. Then check that all parts are firmly attached.

Note: Allow the adhesive to harden for at least 10 minutes before use.

Diploma:

Insert a sealing ring into the 3-way adapter.
Unscrew the existing shower hose and attach it to the 3-way adapter.
Place a sealing ring in the opening of the 3-way adapter and screw it onto the shower.